Note: For the majority of our products, the instructions are located directly on the packaging.
Overview

Screen protector

Clean the display with a suitable cleaner (a household cleaner with alcohol content is recommended) and position it. The tab at the top of the slide indicates the top part. Then start by placing the screen protector in the middle of the screen and smooth it down with a flat object so that all air bubbles dissolve.

Center console cover

Clean the center console with a suitable cleaner (a household cleaner containing alcohol is recommended). Heat the covers for a short time (approx. 1 minute) with a hair dryer.

Remove the back sheet (3M adhesive), Part 1 should be aligned around the cup holder. Parts 2, 3 and 4 each at the edge. Then stick the cover onto the center console with a little pressure. Finally, press down on all edges again, otherwise they will come loose.

You can find video instructions here

Performance pedals

In the case of the footrest (before model year 2020), the somewhat sharp edges on the footrest should be noted. At the beginning please put the pedal pads in warm water for 5 minutes while simply removing the existing pad from the brake pedal. Then cover the two pads from bottom to top. If the "current pedal" pad cannot be attached immediately, you can heat it up again slightly (with a hair dryer) and then walk over the pedal more easily.

3D Premium Mats

You can find instructions in the attached file.

Mud Flaps You can find instructions in the attached file.
Frunk gas spring You can find instructions in the attached file.
Trunk gas spring You can find instructions in the attached file .
Spoilers You can find instructions in the attached file.
Welcome lights You can find instructions in the attached file.

Dual engine logo

You can find instructions in the attached file.

Sun protection glass roof above

You can find instructions in the attached file.

Sunscreen/Privacy Shield

Proceed as follows to darken the interior for camping or to minimize the temperature in the vehicle:

1. Install the sunshade from the inside with the doors closed.

2. To do this, lower the windows a little and attach the Privacy Shield. (For sun protection while driving for the children, lock the lowering of the windows)

3. Please note: As soon as the doors are opened, the sun protection can fall down, so open the doors carefully.

T E S L A Logo You can find instructions in the attached file.
Dashboard cover / dashboard cover

1. Before starting the installation, heat up the car 24. Degree. The covers should also be heated.

2. Thoroughly clean the surface

3. Start attaching the door moldings and press them down firmly.

4. When attaching the dashboard, please note that depending on the manufacturing tolerances at Tesla and us, it sometimes overhangs by a few mm, this is desired. Please divide the overhang onto both sides at the same time.

You can find detailed instructions here

Luggage cover video

V3 There is a video for installation here. Please make sure to insert the cover at the same time horizontally on the right and left in the mounts.

V4 explanation in English by our partner here.

Model 3 rubber mats V2

The fit of our new rubber mats has been further optimized.

They now reach under the driver's seat in the rear part of the passenger compartment. Therefore, for correct installation both seats must be placed all the way up and forward and the mat pushed under with a little pressure during the first installation.

touch-up sticks You can find all the necessary explanation videos on the corresponding article page
Trunk side organizer MY You can find instructions in the attached file.